Installing Batteries In The Remote Control; Charging The 3D Glasses - Epson PowerLite Home Cinema 5020UB User Manual

Installing Batteries in the Remote Control

The remote control uses two AA batteries.
Warning: Keep batteries away from children. If a battery is swallowed, contact your doctor
immediately.
1. Release the tab and lift open the cover.
2. Insert two new AA batteries as shown.
3. Reinsert the cover and press it down until it clicks into place.
Aim the remote control at the screen, or at the front or back of the
projector. Make sure you are within 32 feet (10 meters) of the projector.
If you suspect the batteries are weak, press the
the buttons do not glow, replace the batteries.

Charging the 3D Glasses

If you are using Epson RF 3D Active Shutter Glasses, follow these steps to charge the glasses:
1. Plug a Micro-USB cable into the port on the bridge of the glasses.
Note: Make sure to plug in the connector in the correct orientation so that you don't damage
the cable or the glasses.
22
Setting Up the Projector
illumination button. If