Using Picture-In-Picture - Epson PowerLite Home Cinema 5020UB User Manual

If you have connected a television or other display to the output port on the transmitter and
want to switch between wired and wireless display modes, press the
remote control or transmitter.
Note: The WiHD light on the transmitter will light up when the wireless display mode is active.

Using Picture-in-Picture

If you've connected multiple video sources to the WirelessHD Transmitter, you can use the
Picture-in-Picture (P-in-P) feature to wirelessly project images from two separate video
sources at the same time.
Make sure the video sources you want to project from are turned on, then follow these steps:
1. Press the
2. Do the following to control the P-in-P display:
■
Press the
change the video source displayed in the sub-screen. Keep pressing the button to
cycle through all of the connected video devices.
■
Press the
counter-clockwise from corner to corner each time the
64
Using WirelessHD
Remote control
button on the remote control to enable P-in-P projection.
P-in-P
button on the remote control or the WirelessHD Transmitter to
Input
button to change the position of the sub-screen. The screen moves
Output
Output
WirelessHD Transmitter
Output
button on the
button is pressed.