Starting The Engine; Application Range; Connection - BOLIY Pro3600Si Owner's Manual

AC CONNECTION
ALTERNATING CURRENT (AC)
CAUTION
• Be sure electric devices including the lines and plug connections are in good condition
before connection to the generator.
• Be sure any electric devices are turned off before plugging it in.
• Be sure the total load is within generator rated output.
• Be sure the receptacle load current is within receptacle rated current.
1. Wind the power lead 2 or 3 turns around the carrying handle.
2. Start the engine.
3. Plug in to the AC receptacle.
4. Make sure the AC indicator light is on.
5. Turn on any electric devices.
OVERLOAD INDICATOR LIGHT
The overload indicator light (the AC pilot light) will flash when an overload of connected electrical device is
detected or the inverter control unit overheats. The electronic breaker will then activate, stopping power
generation in order to protect the generator and any connected electric devices, but the engine will not stop
running.
When the overload indicator light comes on and power generation stops, proceed as directed:
1. Turn off any connected electric devices and stop the engine.
2. Reduce the total wattage of connected electric devices within the application range.
3. Check for blockages in the cooling air inlet and around the control unit. If any blockages are found, remove.
4. After checking, restart the engine.
Note: The highest peak load on this model is 3600 watts, the short term peak load is 3300 watts and the
max operating load is 3,000 watts. High temperatures or high elevations will reduce the expected performance
of this generator.
NOTE:
The generator AC output automatically resets when the engine is stopped and restarted.
USING THE GENERATOR FOR BATTERY CHARGING
CAUTION
Do not use AC and DC power at the same time or the generator may be damaged.
NOTE:
The generator DC rated voltage is 12 V.
1. Start Engine
2. Plug in battery charge wires to D.C. receptacle-#14 on CONTROL FUNCTION DIAGRAM
NOTE:
• Make connections to the battery after starting the engine
• Clamp the red wire to the positive(+)terminal and the black wire to the negative(-)terminal of the battery.
Do not reverse these positions.
OPERATION CONTINUED
10