Operation; Starting The Engine; Economy Control Switch - BOLIY Pro3600Si Owner's Manual

STARTING THE ENGINE

NOTE:
Before starting the engine, do not connect any electric devices.
1. Turn the fuel switch lever to the "ON" position.
2. Turn the engine switch to the "ON" position.
3. Please make sure fix cathcode cable to the crank case(Electric start model).
1.
Note: Sometimes the choke is required to start a warm engine.
3. Hold the choke knob fully out.
4. Pull slowly on the recoil starter until it is engaged, then pull it briskly.
start button to start.)
5. After the engine starts, warm up the engine until the engine does not stop when the choke knob is returned
to the original position.
6. Push the choke knob back to the original position.
ECONOMY CONTROL SWITCH (120V/60Hz type have this switch)
Engine speed is kept at idle automatically when the electrical device is disconnected and is returned to the
proper speed by the electrical load when the electrical device is reconnected. The economy control switch in
"ON" position is recommended to minimize the fuel consumption while in normal operation.
NOTE:
When high electrical load devices are connected simultaneously, turn the economy control switch to the "OFF"
position, the engine speed will increase to reduce voltage changes. Otherwise the generator will not operate
sufficiently to run high demand electrical devices.
9
2.
ON
STOP
OFF

OPERATION

ON
(Electric start model can press engine
3.
A
B
D I G I T A L
ENGINE
START
+ -
T E C H
ON OFF
(PUSH)
PROTECTOR