Spark Plug Inspection; Engine Oil Replacement; Fuel Filter; Fuel Tank Filter - BOLIY Pro3600Si Owner's Manual

You should periodically remove and inspect the spark plug.
1. Check for discoloration and remove the carbon.
2. Check the spark plug type and gap.
Standard electrode color: Tan Color
Standard Spark Plug:BPR4ES(NGK)(F7RTC)
Gap:(0.028-0.031 inches)
3. Install the spark plug.
Spark Plug Torque:14 lbs. -Ft.

ENGINE OIL REPLACEMENT

1. Place the machine on a level surface and warm up the engine. Then stop the engine.
2. Remove the rubber cap on the bottom..
3. Place an oil pan under the engine. Remove the drain bolt
4. Open the oil filler cover as shown and remove the oil filler
cap so that the oil can be completely drained.
5. Check the drain bolt, gasket, oil filler gap and O-ring.
6. Reinstall the oil drain bolt.-Drain Bolt Torque:12 Ft. lbs.
7. Add engine oil to the upper level.
• Recommended oil for most climastes:10 W30
• For extremely cold conditions the oil viscosity may be lowered to ease starting: 5W 30
• Engine Oil Quantity:0.63US qt
NOTE:
Recommended engine oil classification: API Service "SE" or "SF"
CAUTION
Be sure no foreign material enters the crankcase.
8. Install the oil filler cap.
9. Install the rubber cap on the bottom.
CAUTION
Be sure to install securely to prevent from falling off during operation.
10. Close the oil filler cover.

FUEL FILTER

WARNING
Do not smoke or have an open flame in the vicinity of the fuel and solvent.
1.Stop the engine:
2.Clamp the fuel line with the clip.
3.Replace the fuel filter.

FUEL TANK FILTER

1. Remove the fuel tank cap and filter.
2. Clean the filter with solvent, if damaged, replace.
3. Wipe the filter and insert it.
WARNING
Be sure the tank cap is securely tightened.

SPARK PLUG INSPECTION

(0.028-0.031 inch)
14