Table of Contents
Advertisement
SBI-7127R-S6 Blade Module User's Manual
3-3
Processor Installation
One or two processors may be installed to the mainboard of each blade unit. See
Chapter 1
for general information on the features of the blade unit and the
web site
for further details including processor, memory and operating system support.
Caution: This action should only be performed by a trained service technician. Allow the
processor heatsink to cool before removing it.
Removing a Processor
1. Power down and remove the blade unit from the enclosure (see
Installing Blade Modules on page 3-1
2. Remove the cover of the blade unit (see
page
3-2).
3. Loosen the four screws that secure the heatsink to the mainboard.
4. Remove the heatsink by gently rotating it back-and-forth sideways with your fingers
to release it from the processor. Set the heatsink aside and upside-down so that
nothing comes into contact with the thermal grease on its underside.
5. Raise the lever of the processor socket up until the processor is released from the
socket, then lift the silver cover plate and remove the processor.
6. Reapply plastic socket covers to the LGA2011 sockets to prevent pin damage.
Installing a Processor
Caution: This action should only be performed by a trained service technician.
Caution: When handling the processor package, avoid placing direct pressure on the label
area.
Caution: Always connect the power cord last, and always remove it before adding,
removing or changing any hardware components. Make sure that you install the processor
into the CPU socket before you install the CPU heatsink.
Caution: Important! If you buy a CPU separately, make sure that you use an Intel-certified
multi-directional heatsink only.
Caution: Make sure to install the system board into the chassis before you install the CPU
heatsink.
Caution: When receiving a server board without a processor pre-installed, make sure that
the plastic CPU socket cap is in place and none of the socket pins are bent; otherwise,
contact your retailer immediately.
for details).
"Removing/Replacing the Blade Cover" on
3-4
Supermicro
Section 3-2:
Advertisement
Table of Contents
