Toshiba e-STUDIO287CS User Manual page 63

Note
• If the inner finisher is installed, be sure to remove any
output paper on it before opening the top cover.
4
Remove the old belt unit.
(1) Remove the four image drum cartridges,
and put them on a table or flat surface.
(2) Cover the image drum cartridges with
paper to minimize their exposure to light.
(3) Turn the two blue lock levers in the
direction of the arrow
unit. Then grip the two levers and remove
the belt unit.
Lock lever (blue)
Top cover
Top cover open button
Image drum
cartridge
to unlock the belt
Lock lever (blue)
Belt unit
- 63 -
Replacing Consumables / Maintenance Units
Memo
• For information on how to return used belt units, see
"Collection of Used Consumables" in the section of
customer support / maintenance product warranty / product
warranty. If you choose not to return your used belt unit,
place it in a plastic bag and dispose of it according to local
regulations.
Note
• The image drums (the green tubes) are fragile; handle them
carefully.
• Do not expose the image drum cartridges to direct sunlight
or strong light (more than about 1,500 lux). Do not expose
them to room lighting for more than 5 minutes.
Never put a used belt unit into a
Warning fire. It could explode and cause
burns.
5
Install the new belt unit.
(1) Remove the new belt unit from its
packaging.
(2) Grip the two blue belt unit levers and install
the belt unit.
Belt unit
(3) Rotate the two blue lock levers in the
direction of the arrow
the belt unit is secure.
Lock lever
(blue)
1
2
3
4
Lever (blue)
, and confirm that
Lock lever
(blue)
5
6
7