Table of Contents
Advertisement
Chapter 2
2.1 Hardware Installation
Follow the instructions below to complete the hardware connections.
Connection to LINE port
If you wish to connect both the router and a telephone, connect the LINE port to a
POTS splitter with a RJ11 connection cable.
Connection to LAN port
To connect to a hub or PC, use a RJ45 cable. The port is auto-sensing MDI/X and
either straight-through cable or crossover cable can be used.
Connection to USB port
Connect the USB port to a PC with a standard USB cable.
Connection to Power
Connect the Power jack to the shipped power cord. Attach the power adapter to the
wall outlet or other AC source.
After all connections have been made, turn the power-switch to the on position. After
powering on, the router performs a self-test. Wait for a few seconds until the test is
finished, then the router will be ready to operate.
Reset Button
Restore the default parameters of the router by holding down the device's Reset button
until the LED's start blinking simultaneously (about 5 seconds). After the device has
rebooted successfully, and if the connection is established, the LAN LED, ADSL LED or
USB LED will display in green, depending on the connection type.
Caution 1:
If the router fails to power up, or it malfunctions, first verify that the
power supply is connected correctly. Then power it on again. If the
problem persists, contact our technical support engineers.
Caution 2:
Before servicing or disassembling this equipment always disconnect
all power cords and telephone lines from the wall outlet.
Installation
8
Reset Button
Advertisement
Table of Contents
