Husqvarna 10530SBEB Owner's Manual page 7

ASSEMBLY / PRE-OPERATION
INSTALL DISCHARGE CHUTE / CHUTE ROTATER HEAD
(See Fig. 7)
NOTE: The multi-wrench provided in your parts bag may
be used to install the chute rotater head.
1. Place discharge chute assembly on top of chute base
with discharge opening toward front of snow thrower.
2. Position chute rotater head over chute bracket. If nec-
essary, rotate chute assembly to align square and pin
on un derside of chute rotater head with holes in chute
bracket.
3. With chute rotater head and chute bracket aligned,
position chute rotater head on pin and threaded stud
of mounting bracket.
4. Install 3/8 washer and locknut on threaded stud and
tighten securely.
CHUTE
ROTATER
HEAD
CHUTE ALIGN BEFORE
BRACKET TIGHTENING LOCKNUT
3/8 LOCKNUT
3/8 WASHER
THREADED
STUD
ROTATER HEAD
MOUNTING
BRACKET
FIG. 7
INSTALL CHUTE DEFLECTOR REMOTE CONTROL
(See Figs. 8 and 9)
1. Install remote cable bracket to discharge chute with
5/16-18 carriage bolt, 5/16 fl at washer and 5/16-18
locknut as shown. Tighten securely.
2. Install remote cable eyelet to chute defl ector with
1/4-20 shoulder bolt, nylon friction washer and 1/4-20
locknut as shown. Tighten securely.
3. Install spring hooks between hex nuts on chute rotater
head and into hole in chute defl ector as shown.
CHUTE
DEFLECTOR
NYLON
WASHER
CABLE
EYELET
1/4-20
LOCK-
NUT
REMOTE
CABLE
BRACKET
WASHER
PIN
5/16-18
LOCKNUT
CHECK TIRE PRESSURE
The tires on your snow thrower were overinfl ated at the fac-
tory for shipping purposes. Correct and equal tire pres sure
is important for best snow throwing performance.
• Reduce tire pressure to 14-17 PSI.
7
SPRING
FLAT
FIG. 8
CHUTE DEFLECTOR
CONTROL LEVER
FIG. 9
1/4-20
SHOULDER
BOLT
HOOK BE TWEEN
HEX NUTS
ON CHUTE
ROTATER HEAD
5/16-18
CARRIAGE
BOLT