Plug-In Program Switch; Transmitter/Receiver Learn Routine - Auto Mate AM6.2 Installation Manual

plug-in program switch

The Program switch plugs into the blue two-pin connector.

transmitter/receiver learn routine

The system comes with two transmitters that has been taught to the receiver. The receiver can store up to 4 dif-
ferent transmitter codes in memory. Use the following learn routine to add transmitters to the system.
The Program switch, plugged into the blue port, is used for programming. There is a basic sequence of steps to
remember whenever programming this unit: Key, Choose, Transmit and Release.
1.
2.
26
Key. Turn the ignition to the ON position.
Choose. Within 10 seconds, press and release the Program switch the number of times cor-
responding to the desired channel listed below. Once you have selected the channel, press
the switch once more and HOLD it. The LED will flash to confirm the selected channel. Do
not release the Program switch.
© 2003 Directed Electronics, Inc. Vista, CA