Delivery Service - Husqvarna ZTH5223 Workshop Manual

The baseplate itself stands on a pallet and the whole assembly can be handled using a standard forklift
truck. To keep the goods as level as possible, two people should assist the truck driver. Driving and lifting
must both be performed with care.
Remove the upper part of the crate from the wooden baseplate.
The mower (rear wheels not fitted) is secured to the baseplate by plastic straps and wooden blocks. Certain
components that are to be fitted to the mower, or handed to the purchaser on delivery, are wrapped
separately in plastic bags.
Remove the plastic sheeting covering the mower.
When unpacking the mower, check that there is no transport damage. Any damage is to be reported to the
transport company in the normal way.
The packaging is not to be returned.

Delivery Service

1. Charge the battery. The mower is
normally delivered with a charged
battery topped-up with electrolyte.
2. Raise the rear of the mower until it is
clear of the baseplate and the rear
wheels can rotate freely. Hold firmly in
position using blocks or jack stands.
3. With the valves facing outwards, fit the
rear wheels. Fit and tighten the wheel
nuts on the wheel bolts.
4. Check and adjust the pressure in all the
tires. The recommended pressure is 1
bar (15 PSI).
5. On both motion control levers, remove
the lower bolts and loosen the upper
bolts. Swing the levers to the upright
position. Hand tighten the lower bolts in
the rectangular holes. The levers are
adjusted at a later stage.
6. Push the levers out into their neutral
slots.
20
English-
DELIVERY SERVICING
Fitting the rear wheels
Lever mount
8011-503
8011-502