Fuel Tank - Husqvarna ZTH5223 Workshop Manual

Fuel tank

Removing
Before removing the tank on the right of the mower, the rear wheel and the bolts holding the oil cooler for
the hydraulics must be removed.
1. Close the fuel valve (13).
WARNING!
Fire and health hazard.
Avoid spills.
Wipe dry if necessary.
2. Drain the tank that is to be removed.
Keep the drained fuel in a closed
container.
3. Remove the hose clamp (5) from the fuel
line (6).
4. To catch any spills, position a container
below the outlet from the tank to the fuel
line. To ensure no damage is caused,
hold the hose barb (4) with pliers and pull
the fuel line away. Even when the tank is
empty, a small amount of fuel may leak
out.
5. The tank is fitted to the splashguard by a
bolt and two studs. Remove the bolt (16)
and three nuts (10) - all with washers (8)
and springs (9) - located on the
underside of the splashguard.
6. Remove the bolt (12) and tank spacer
located on the inside of the splashguard.
7. Lift the fuel tank (2) away.
Fitting
The fitting procedure is the reverse of the removal procedure.
Working from the underside of the splashguard, tighten each washer (8) spring (9) washer (8) combination
using the appropriate nut (10) or bolt (16). Tighten until the spring starts to compress and then a further 1.5
turns.
REPAIRS
Fuel tank
8011-607
33
English-