Table of Contents
Advertisement
Chapter 2: Setting up the CacheRaQ 4
Connecting the power supply
Connect the power supply cord to the CacheRaQ 4 and to an electrical outlet
(100-240 volts AC, 50/60 Hz, as listed in Appendix B, "Product Specifications").
Powering on the CacheRaQ 4
Turn on the power by pressing the On/Off switch on the back panel.
The hard disk spins up, the fan turns on, and the LCD screen lights up. The
Cobalt logo and the Cobalt Networks name scroll across the screen.
A number of status messages are displayed on the LCD screen as the
CacheRaQ 4 completes its boot process.
Caution: It is important to follow the proper power-down
procedure before turning off the CacheRaQ 4. Refer to "Power
!
down" on page 58.
Configuring the CacheRaQ 4 for the network
Now that you have made the network and power connections, you can configure
the network settings.
The CacheRaQ 4 requires specific network information to function properly. You
must enter the necessary information using the LCD console on the front panel.
Before you proceed, make sure you have the following information:
•
the IP address assigned to the CacheRaQ 4
•
the subnet mask of your network
•
the gateway/router address (necessary only if communicating with other
networks)
14
Cobalt CacheRaQ 4 User Manual
Advertisement
Table of Contents
