Table of Contents
Advertisement
Chapter 1: Introduction
General
Figure 1 and Figure 2 show the CacheRaQ 4 controls, indicators and connectors.
Front view of the CacheRaQ 4
Figure 1. CacheRaQ 4 front view
1
1. The Status Indicators signal Ethernet and hard drive activity:
Tx/Rx (Transmit/Receive) blinks when there is network traffic on the
primary interface.
Link indicates an active network connection on the primary interface.
Col blinks when a collision is detected on the primary interface.
100 M indicates that 100BaseT ethernet is being used on the primary
interface.
Disk indicates activity on the hard disk drive.
2.
The Web indicator blinks to indicate Web activity.
3. The Logo Badge glows when the CacheRaQ 4 is powered on.
4. The LCD Screen displays messages and entered values.
5.
You can use the recessed Reset Password button if you forget the
CacheRaQ 4 Administrator password. (See "Resetting the CacheRaQ 4
Administrator password" on page 60.)
6. The LCD arrow buttons allow you to enter network configuration
information, shut down and reboot the CacheRaQ 4. (See "Using the LCD
console to configure the network" on page 15.)
2
2
3
Cobalt CacheRaQ 4 User Manual
4
5
S
E
6
Advertisement
Table of Contents
