Cutting Height Adjustment - Husqvarna WH4817E, WH3615E Operator's Manual

Cutting height adjustment

The cutting height can be adjusted by three
methods:
• Moving spacers between the upper side
and the lower side of the caster swivel
according to "Cutting height table". For
instruction, see below.
• Moving spacers between the upper side
and the lower side of the blades
according to "Cutting height table". For
removing and installation of blades,
contact your Husqvarna dealer.
• Cutting deck height adjustment
according to the following instruction.
1. Before changing cutting heights make
sure the blades are off, key switch is off,
and remove spark plug wires.
2. Cutting height ranges from 1 1/2" to 5" in
1/4" increments. Factory setting is 3".
3. Cutting height can be changed three
ways. Move one "C" spacer on the front
casters, change the blade spacers, or
change rear deck position.
4. a.
To change heights on the rear deck
loosen, but do not remove the middle
bolt on each side of the rear deck, and
the two bolts on the front side of the rear
deck. See illustration "Loosen these
screws".
b.
Push down on the handles and lift the
rear of the cutting deck up off of the
ground. Block the rear of the cutting deck
off of the ground the following distances
(boards work well).
- Deck Position A: 3 1/4"
- Deck Position B: 2"
- Deck Position C: 3/4"
Lower the deck down onto the blocks.
Now remove the outer three bolts on
each side of the rear deck. See
illustration "Remove these screws".
OPERATION
Loosen these screws
Remove these screws
8011-406
8011-407
31
English-