Recoil Starter Grip; Ground Speed Lever - Husqvarna WH4817E, WH3615E Operator's Manual

1. Recoil Starter Grip

IMPORTANT INFORMATION
Do not let recoil cord snap back by itself.
This may damage the cord or the recoil
starter assembly.
Pull the recoil starter grip slowly until you feel
compression, then pull it briskly.
Normally this engine will not backfire. If you
get backfires, contact your Husqvarna dealer
for service.

2. Ground Speed Lever

Located in the center of the console. Controls
the forward speed of the mower. Push the
lever forward if you want to go faster, pull it
back to go slower or pull it all the way back to
the stop postion.
To begin motion, the operator must move the
ground speed lever forward before
disengaging the neutral lock bail.
Ground Speed Lever Stop is the adjustment
screw placed on the front edge of the driver´s
panel. It is used to insure ground speed lever
does not over travel drive levers into reverse.
CONTROLS
Recoil starter grip
Ground Speed Lever
8011-435
8011-654
15
English-