Husqvarna WH4817E, WH3615E Operator's Manual page 27

4. Adjust choke (if needed)
Do not use choke when the engine is
warm.
5. Turn ignition key to ON position.
IMPORTANT INFORMATION
Do not let recoil cord snap back by itself.
This may damage the cord or the recoil
starter assembly.
6. Pull the recoil starter grip slowly until you
feel compression, then pull it briskly.
If the engine won´t start in three pulls,
open the choke and try again.
WARNING!
Be sure all persons are clear of
area before engaging the
blades.
IMPORTANT INFORMATION
To prolong spindle bearing, clutch and belt
life, engage and disengage blades at
approximately ½ throttle.
7. Pull the ground speed lever fully back.
OPERATION
Choke control
Ignition key
Pull the starter grip
8011-652
8011-656
8011-435
25
English-