Information Centers Of The Xc Series; Remote Display - Xantrex XC3012 Owner's Manual

Introduction

Information Centers of the XC Series

Remote Display

This section describes the parts of the remote display of the XC Series. The remote
display can be rotated 180°, or it can be removed and remotely mounted up to 20 m
(65 ft) from the XC Series for convenience. Figure 1-2 shows the remote display.
A "press and hold" action on the remote display means that the button must be held
down for more than 2 seconds in order to send the instruction. A "press" action on
the remote display means that the button must be pressed and released before 2
seconds have elapsed.
1
Figure 1-2 XC Series Remote Display
Item Description
1 /
ON STANDBY
• Press to turn on or disable the charger while AC power is connected
• Press and hold to apply selection when in setup or equalization mode
• Press to show battery bank voltages when AC is disconnected
2 Battery bank indicator lights
• Illuminate to show which bank has been selected for setup or status display
• Illuminate during a fault or warning to show which bank has the fault or warning, or
illuminate all three if the charger itself has the fault or warning
1–4
2 3
push button
4 5
6
7
975-0187-01-01