Insight Display Signal Pass-Thru Board - HP BladeSystem c7000 Maintenance And Service Manual

Remove the two slotted T-15 Torx screws that secure the interconnect board.
15.
Remove the interconnect board.
16.
To replace the component, reverse the removal procedure.

Insight Display signal pass-thru board

WARNING:
remove or disengage and extend all blades and power supplies approximately 8 cm (3 in) before
removing or installing the rear cage.
To remove the component:
Power down the server blades
1.
Power down the enclosure (on page 29).
2.
Disconnect all cables.
3.
To reduce the risk of damage to the midplane and component connectors, always
("Power down the server blades or workstation blades" on page 28).
Removal and replacement procedures 49