Half-Height Or Full-Height Blade - HP BladeSystem c7000 Maintenance And Service Manual

Lift the left side of the device bay shelf to disengage the three tabs from the divider wall, and then
4.
remove it from the enclosure.
To replace the component, reverse the removal procedure.

Half-height or full-height blade

CAUTION:
the configuration of components, see the appropriate HP BladeSystem c-Class enclosure setup
and installation guide.
The c7000 enclosure is divided into four quadrants by the vertical support metal work. Within each
quadrant, a removable divider supports half-height blades. To install a full-height blade in any quadrant, this
divider must be removed. Therefore, a quadrant can only contain either full-height blades or half-height
blades.
CAUTION:
result in damage to the connectors on the server blades.
This procedure provides instructions for replacement of a failed part only. To change
Failure to install the divider in a quadrant when installing half-height blades can
Removal and replacement procedures 34