Power supplies
o
Remove the fans
("Active Cool 200
5.
Remove the interconnect switches and Pass-Thru modules
6.
page 40).
Remove the Onboard Administrator modules
7.
Remove the Onboard Administrator tray
8.
Remove the rear cage.
9.
Loosen the thumbscrews, and then open the hinges completely.
a.
Use the handles to extend the rear cage until the release levers engage on both sides of the rear
b.
cage.
Grasp the handholds below the release levers.
c.
Disengage the release levers on both sides of the rear cage.
d.
("HP BladeSystem c7000 power supply or power supply
fan" on page 39).
("Onboard Administrator
("Interconnect switch or Pass-Thru
("Onboard
Administrator" on page 43).
tray" on page 43).
Removal and replacement procedures 46
blank" on page 30)
module" on