Section 13-Options; Using The Ventilator Tray - Invacare Orbit Owner's Operator And Maintenance Manual

SECTION 13—OPTIONS
SECTION 13—OPTIONS
After any adjustments, repair or service and before use, make sure all attaching
hardware is tightened securely. Otherwise injury or damage may occur.
RECLINER MODELS ONLY - If the ventilator, ventilator battery, or ventilator tray
option is removed, the recliner limit stop MUST be installed before operation of the
wheelchair. Otherwise, injury or damage may result.

Using the Ventilator Tray

NOTE: For this procedure, refer to FIGURE 13.1.
1. Position all four straps to the outside of the ventilator tray.
2. Position the ventilator battery in the front portion of the ventilator tray.
3. Secure the two straps around the top of the ventilator battery and clip together.
4. Position the ventilator in the rear portion of the ventilator tray.
5. Secure the two straps around the top of the ventilator and clip together.
6. Adjust the slides, located in the middle of each strap, up or down to increase or
decrease length. (See Detail "A").
7. Securely tighten the straps around the battery and ventilator by pulling the ends of the
straps through the rear portion of each buckle. (See Detail "B").
Slide
Rear
Portion
of Buckle
™
Orbit
WARNING
Ventilator
DETAIL "A"
Battery
Strap
Buckle
DETAIL "B"
Strap
Front
Portion
FIGURE 13.1 Using the Ventilator Tray
Ventilator
Tray Slide
82
See
DETAIL "B"
See
DETAIL "A"
Rear
Portion
Part No. 1073955