Adjusting The Back Height - Recliner Models Only - Invacare Orbit Owner's Operator And Maintenance Manual

FIGURE 11.4 Replacing Upholstery (Recliner Models Only)

Adjusting the Back Height - Recliner Models Only

NOTE: For this procedure, refer to FIGURE 11.5.
1. If necessary, remove the rear wheels. Refer to Removing/Installing Rear Wheels on
page 61.
2. Remove the two mounting screws and locknuts that secure the seat adjustment plates
to the seat rail. Repeat for opposite side.
3. Refer to FIGURE 11.5 to determine the seat adjustment plate mounting position for the
corresponding seat cushion height.
4. Position the seat adjustment plates on the seat rails at the position determined in STEP
3.
5. Secure the seat adjustment plates to the seat rail with the two existing mounting
screws. Repeat for opposite side.
6. Securely tighten mounting screws.
7. If necessary, reinstall the rear wheels. Refer to Removing/Installing Rear Wheels on
page 61.
Cushion Position
3-inch Seat
Cushion Position
Mounting
Screws
FIGURE 11.5 Adjusting the Back Height - Recliner Models Only
Part No. 1073955
Headrest Upholstery
Headrest
Extension
Back Cane
2-inch Seat
Phillips
Screws
Back
Upholstery
Locknuts
Washers
75
SECTION 11—RECLINER
Orbit
™