Optional Footrest Accessories - Invacare Orbit Owner's Operator And Maintenance Manual

FIGURE 5.13 Installing/Removing/Adjusting the Telescoping Front Frame Tubes

Optional Footrest Accessories

Replacing Heel Loop
Composite Footplates
NOTE: For this procedure, refer to FIGURE 5.14.
1. Remove the mounting screw and coved washer that secures the lower footrest
assembly to the swingaway footrest assembly.
2. Remove the lower footrest assembly.
3. Remove the mounting screws and locknuts that secure the heel loop to the footrest.
4. Slide existing heel loop up and off slide tube.
5. Slide new heel loop onto slide tube.
6. Reverse STEPS 1‐4 to reassemble.
NOTE: When securing the heel loop to the footrest assembly, tighten the phillips screw and locknut
until the spacer is secure.
Swingaway Footrest
FIGURE 5.14 Replacing Heel Loop - Composite Footplates
Part No. 1073955
Seat Rail
Mounting
Screw
Assembly
Mounting screw/
Coved Washer
Slide
Tube
Lower Footrest
Assembly
39
SECTION 5—FRONT RIGGINGS
Locknut
Telescoping
Tube
Mounting Screw
Spacer
Heel Loop
Footplate
Locknut
™
Orbit