Figure 8-6 Removing Or Replacing A Power Supply-Sun Fire 6800 System - Sun Microsystems Fire 6800 Service Manual

3. Loosen the two captive screws (
Ejector lever
Captive screws
FIGURE 8-6
4. Unlock the ejector by pulling the ejector down.
5. Slide the power supply out.
6. Install a power supply filler panel to cover the empty slot. Tighten the captive
screws.
8.1.3.2 Installing a Sun Fire 6800 or Sun Fire 4810 System Power
Supply
1. Remove the power supply filler panel.
2. Slide the power supply into the slot (
3. Lock the ejector by pushing the ejector up.
4. Tighten the two captive screws.
Note – Install power supply filler panels to cover any empty slots.
5. Make sure that the appropriate power switch on the AC input box for the new
power supply is on.
6. Make sure the green Activated LED is lit.
If the green Activated LED is not lit:
8-8 Sun Fire 6800/4810/4800/3800 Systems Service Manual • April 2001
Removing or Replacing a Power Supply—Sun Fire 6800 System
).
FIGURE 8-6
).
FIGURE 8-6