OPERATING INSTRUCTIONS
MOVE
4.6.12 Move Memory
MOVE <address1> <address2> [<dest>]
where:
<address1>
<address2>
[<dest>]
The MOVE command allows the user to copy/move memory to new memory locations. If the
destination is not specified, the block of data residing from address1 to address2 will be moved
up one byte. Using the MOVE command on EEPROM locations will program EEPROM cells.
No messages will be displayed on the terminal CRT upon completion of the copy/move
operation, only the prompt is displayed.
Example:
>MOVE E000 E0FF 0100<CR>
>
4-26
Memory starting address.
Memory ending address.
Destination starting address (optional).
Move data from locations $E000-$E0FF to locations
$0100-$01FF.
Move Memory
M68HC11EVBU/D