Erase All Eeprom Locations - Motorola M68HC11EVBU User Manual

BULK
4.6.4

Erase All EEPROM Locations

The BULK command lets you erase all MCU EEPROM locations ($B600-$B7FF). A delay loop
is built in such that the erase time is 10 ms when running at 2 MHz E clock.
No erase verification message will be displayed upon completion
of the bulk EEPROM erase operation. User must verify erase
operation by examining EEPROM locations using the MM or MD
command.
Example:
>BULK<CR>
>
M68HC11EVBU/D
Erase All EEPROM Locations
NOTE
Bulk erase all MCU EEPROM locations ($B600-$B7FF).
Prompt indicates erase sequence completed.
OPERATING INSTRUCTIONS
4-15