Table of Contents
Advertisement
Console command-line commands
To enable the remote console password, enter
ENABLEPW R
Note: The ENABLEPW command is accessible only from the local
console.
DISABLEPW
DISABLEPW disables the password for the local and remote console.
When the password is disabled, users must specify the correct password
before they can gain access to console services. The default values are local
password DISABLED and remote password ENABLED.
To disable the local console password, enter
DISABLEPW L
To disable the remote console password, enter
DISABLEPW R
Note: The DISABLEPW command is accessible only from the local
console.
WHERETO
WHERETO displays the port numbers to which frames destined to a
specified MAC address are forwarded.
To display the port numbers to which frames are forwarded, enter
WHERETO [MAC address]
Use spaces or hyphens between bytes of the Mac address to indicate
canonical format. See "Port address formats" on page 66.
TAP
TAP specifies a port, designated by the port number, to be the traffic
analyzer port (TAP). The TAP transmits all frames that were received
(accepted for forwarding) from all other ports.
Specifying a port number of 0 (zero) disables the TAP.
To specify a port as the TAP, enter
TAP [port_number]
54 WaveSwitch 100 Ethernet Switch User Manual
12195
Advertisement
Table of Contents
