Connecting power to a WaveSwitch 100 Ethernet Switch
Connecting power to a WaveSwitch 100 Ethernet Switch
Make sure the power switch on the front of the unit is in the off (
O
)
position.
Plug one end of the power cord supplied with the WaveSwitch 100 into the
IEC power entry connector on the front of the unit.
Plug the other end of the power cord into a grounded AC outlet. For more
information about power requirements and environmental requirements, see
"General specifications" on page 45.
Apply power by setting the power switch to the on (
) position.
I
WaveSwitch 100 Ethernet Switch User Manual 13