Mib-Ii Objects - Plaintree WaveSwitch 100 User Manual

MIB-II objects

MIB-II objects
The WaveSwitch 100 agent supports selected MIB-II objects. MIB-II is
described in RFC 1213.
The WaveSwitch 100 supports MIB-II variables that belong to the following
object groups and begin with the corresponding prefixes:
•
system (sys)
•
interfaces (if)
•
Internet Protocol (ip)
•
Internet Control Message Protocol (icmp)
•
Transmission Control Protocol (tcp)
•
Unnumbered Datagram Protocol (udp)
•
Simple Network Management Protocol (snmp)
The following table describes the MIB-II objects. For each object, the
object name, data type, (range of) values, access privileges (R or R/W),
description, and default value are given. The default values are preset at the
factory.
Some object groups are not supported. If you try to read or write variables
for objects belonging to unsupported groups, the management program
displays the message
Some variables within the supported object groups are not supported by the
SNMP agent because the variables are not relevant to the WaveSwitch 100.
When an unsupported variable is read, the SNMP agent displays the null
value of the variable. If you try to write a value other than the default null
value to an unsupported variable, the management program displays the
message
WaveSwitch 100 Ethernet Switch 12195 User Manual
114 WaveSwitch 100 Ethernet Switch User Manual
NO SUCH NAME
.
BAD VALUE
.
12195