Power Led/Speaker; Bmc (X7Spa-Hf Only) - Supermicro Super X7SPA-L User Manual

Power LED/Speaker

On the JD1 header, pins 1~3 are used
for a power LED and pins 4~7 are
used for an external speaker. If you
wish to use the onboard speaker, you
should close pins 6-7 with a jumper.
See the table on the right for speaker
pin definitions.

BMC (X7SPA-HF Only)

The JPB jumper is used to enable or
disable the on-board Baseboard Man-
agement Controller (BMC) and the
on-board IPMI feature. This jumper is
used together with the IPMI settings in
the BIOS. The default position is pins
1 and 2 to enable BMC. See the table
on the right for jumper settings.
KB/MOUSE
COM1
J10
J11
JVGA1
LAN1
LAN2
AUDIO FP
CD-in
JSMB1:SMBus1
JSMB1
FAN1 FAN2
SYS FAN
J13
JPC3
J12
B
JPL1
JI2C1 JPL2
JL1
JPCIE1 SLOT1 PCI-E X4 (IN X16 SLOT)
JI2C1 ON:ENABLE
OFF:DISABLE
2-27
Chapter 2: Installation
Speaker Connector
Pin Definitions
Pin Setting
Pins 6-7
Pins 4-7
Pin Definitions
Pin Setting
Pins 1-2
Pins 2-3
Power LED/Speaker
A
B
BMC Enable
JLPC80
JBT1:
COMS CLEAR
T-SGPIO2
T-SGPIO1
JI2C2 ON:ENABLE
+
OFF:DISABLE
SP1
JBAT1
JPG1
JBMC1
X7SPA-L
REV:1.00
Definition
Internal Speaker
External Speaker
BMC
Definition
Enabled (Default)
Disabled
JPW1
JPI2C1
A
I-SATA2 I-SATA1 I-SATA0
J2
I-SATA5 I-SATA4 I-SATA3
D17
J8
JPUSB1
JOH1
JUSB4
JUSB3