System Memory; How To Install So Dimms; Memory Support - Supermicro Super X7SPA-L User Manual

X7SPA-L/X7SPA-H/X7SPA-HF User's Manual
2-3

System Memory

Exercise extreme care when installing or removing
Note: Check the Supermicro website for a list of memory modules that
have been validated with the X7SPA-L/X7SPA-H/X7SPA-HF mother-
board.

How to Install SO DIMMs

1. Insert the desired number of SO DIMMs into the memory slots, starting with
DIMM1, then DIMM2. Pay attention to the notch along the bottom of the mod-
ule to prevent incorrect DIMM module installation.
2. Insert each DIMM module at an angle vertically and snap it into place. Repeat
step 1 to install DIMM2 if needed. See instructions on the next page.

Memory Support

The X7SPA-L/X7SPA-H/X7SPA-HF supports up to 4GB of unbuffered Non-ECC
DDR2 SODIMMs (667MHz in 2 SO DIMM slots.) Populating these DIMM slots with
a pair of memory modules of the same type and same size will result in interleaved
memory, which will improve memory performance.
KB/MOUSE
FAN1 FAN2
SYS FAN
KB/MOUSE
COM1
J10
J11
COM1
J13
J12
JVGA1
LAN1
LAN2
AUDIO FP
JI2C1
JPCIE1
CD-in
JVGA1
DIMM modules to prevent any possible damage.
Installing and Removing DIMMs
JSMB1:SMBus1
JSMB1
JLPC80
FAN1
J10
J11
JBT1:
COMS CLEAR
JPC3
T-SGPIO2
+ JI2C2 ON:ENABLE
OFF:DISABLE
SP1
JBAT1
JPL1
JPL2
JL1 JPG1 JBMC1
X7SPA-L
SLOT1 PCI-E X4 (IN X16 SLOT)
JI2C1 ON:ENABLE REV:1.00
OFF:DISABLE
J13
J12
LAN1
CAUTION
JPW1
JSMB1:SMBus1
JSMB1
JLPC80
FAN2
SYS FAN JPI2C1
I-SATA2 I-SATA1 I-SATA0
T-SGPIO1 J2
I-SATA5 I-SATA4 I-SATA3
J8 D17
JPUSB1
JOH1
JUSB4
JUSB3
DIMM2
JPC3
2-4
Memory
Bank
DIMM1
JBT1:
COMS CLEAR
J2
T-SGPIO2 T-SGPIO1
JI2C2 ON:ENABLE
+
OFF:DISABLE
SP1
JPW1
JPI2C1
I-SATA2 I-SATA1 I-SATA0
I-SATA5 I-SATA4 I-SATA3