Overheat/Fan Fail Led (Joh); Front Panel Audio Header - Supermicro Super X7SPA-L User Manual

X7SPA-L/X7SPA-H/X7SPA-HF User's Manual

Overheat/Fan Fail LED (JOH)

The JOH header is used to connect an LED
to provide warnings of chassis overheat.
This LED will also blink to indicate a fan
failure. Refer to the table on right for pin
definitions.

Front Panel Audio Header

The Front Panel Audio header is used to
connect the chassis' front panel High Definition
Audio (HDA) controls to the motherboard. See
the table on the right for pin definitions.
KB/MOUSE
FAN1
COM1
J10 J11
J13
JVGA1 J12
LAN1
B
LAN2
AUDIO FP
CD-in
JSMB1:SMBus1
JSMB1
JLPC80
FAN2
FAN
SYS
JBT1:
COMS CLEAR
JPC3
T-SGPIO2
JI2C2 ON:ENABLE
+
OFF:DISABLE
SP1
JBAT1
JPL1
JI2C1
JPL2 JL1 JPG1
JBMC1
SLOT1 PCI-E X4 (IN X16 SLOT) X7SPA-L
JPCIE1
JI2C1 ON:ENABLE REV:1.00
OFF:DISABLE
High Definition Front Panel
Pin#
1
2
3
4
5
6
7
8
9
3
JPW1
JPI2C1
I-SATA1
J2 I-SATA2 I-SATA0
T-SGPIO1
I-SATA5 I-SATA4 I-SATA3
A
D17
J8
JPUSB1
JOH1
JUSB4
JUSB3
2-18
Overheat LED
Pin Definitions
Pin# Definition
1 5vDC
2 OH Active
OH/Fan Fail LED
Status Message
State Message
Solid Overheat
Blinking Fan Fail
Audio
Signal
MC_L
AUD_GND
MC_R
FP_Audio-Detect
Line_2_R
Ground
FP_Jack-Detect
Key
Line_2_L
Ground
A
OH/FF LED (JOH)
B Front Panel Audio