Install Battery; Remove Battery; Charging Your Battery - Pantech Verizon Jest 2 User Manual

INSTALL BATTERY

1. Insert your finger tip into the slot (1), then push down on
top of the battery cover and slide it off to remove (2).
2. Slide the battery into the slot (3) by aligning the contacts
and press down (4) until you hear the "click".
Correct
3. Align the cover tabs with the slots on the back of the
device and slide the battery cover onto the unit until it
snaps into place.
If the battery is not correctly placed in the compartment, the
handset will not turn on and/or the battery may detach during use.
Correct
20
Incorrect
Incorrect

REMOVE BATTERY

1. To remove the battery cover, insert your finger tip into the
slot (1), then push down on top of the battery cover and
slide it off (2).
2. Insert your fingernail into the slot and lift the battery (3),
and pull the battery (4).
3. Align the cover tabs with the slots on the back of the
device and slide the battery cover onto the unit until it
snaps into place.

CHARGING YOUR BATTERY

1. Connect the USB data cable into the cableless wall
adapter.
2. Plug the USB data cable into the phone' s Charging/
Data Port (making sure to align the connector as it
appears in the image to the right) and the wall adapter
end into an electrical outlet.
• If the battery connector is not properly aligned, damage
could occur to the charging connector and the phone may not charge.
• The main plug is used as the disconnect device and remains readily operable.
01
02
03
04
05
06
07
21 20