Table of Contents
Advertisement
Adjusting sound
By means of the Beo4 remote control
you can adjust the sound from the
speakers connected to your BeoCenter
2300.
Pressing LIST enables you to access the
cue A.SETUP*. You may now adjust the
sound coming out of the speakers by
means of the cues BASS, TREBLE and
LOUDNESS and, if you wish, you can
store the sound levels you adjust.
All the current sound levels (volume,
balance, bass, treble and loudness) will
be stored simultaneously.
Pressing LIST to access SOUND*, will
allow you to switch between mono and
stereo sound on a radio program.
If you choose not to store the sound
levels you adjusted, all the sound levels
will be reset to their original settings
when you switch off the BeoCenter
2300.
*
Note:
To be able to display A.SETUP, RESET, SPEAKER
and SOUND in the Beo4 display, you must add the
functions to Beo4's list of functions, please refer
to Beo4's own User's guide and the chapter
'Customising your Beo4' for further instruction:
• Add A.SETUP to Beo4 to be able to adjust sound
levels and store them.
• Add SOUND to Beo4 to be able to switch
between mono and stereo sound.
Raises the volume
Lowers the volume
Press right on the middle to silence the speakers
immediately
Press again to recall the sound
Press to display SPEAKER*
Adjusts balance to the left
Adjusts balance to the right
Press to display A.SETUP*
Press to display BASS
More bass
Less bass
Press to display TREBLE
More treble
Less treble
Press to display LOUDNESS
Sets loudness on
Sets loudness off
Adjust the various sound levels to your liking,
then...
Press to display A.SETUP*
Press to display S.STORE
Press to store the new sound levels
as a permanent setting
25
LIST
s s
or
t t
LIST
then
GO
LIST
or
LIST
or
LIST
or
LIST
then
GO
LIST
GO
Hide quick links:
Advertisement
Table of Contents
