Table of Contents
Advertisement
12
> Using the CD player
Searches forward toward the end of
the CD
Searches backward toward the
beginning of the CD
Keep the button depressed until you
have reached the point you want
Starts scanning the CD
SCAN
The cue SCAN lights up in the upper
display, and the lower display shows
the elapsed time of each track
Cancels the scanning process and
PLAY
plays the remaining tracks in full
If you want to play the CD from the
beginning, press 1 instead
Searching through a CD
You can search through the CD and
start playing at any point you like – just
as if you were fast forwarding or
rewinding an audio tape.
>>
You will use the buttons
search through the CD (forward or
backward).
Searching will continue for as long as
you keep your finger on the button – at
a low speed to begin with, and after 3
seconds at a high speed.
Scanning a CD
The scan function enables you to play
only the first 15 seconds of each track
on the CD.
The scan function may be used in
combination with some of the other
functions in the system.
While a CD is being scanned, you may
for example program a sequence of
tracks, or you may program the CD to
play only your favourite tracks every
time you load it.
See pages 13 and 14 for details of these functions.
When you lift your finger off the
button, the CD resumes playing. Or it
will pause again, if it was pausing when
you started the search.
<<
or
to
You can keep track of the search
process by watching the lower display,
which will read out either track number,
track time, or remaining time, depend-
ing on which display mode it has been
set to.
Note: If the display has been set to showing the
name of the CD, only the name will appear in the
display and of course you cannot follow the
search process. See the previous page for details
of the various display modes.
When the entire CD has been scanned,
playing starts automatically from the
beginning, that is, at track 1, or at the
first track in a programmed sequence, if
any.
Note: When scanning is started, the lower display
automatically changes to showing the elapsed
time of each track. This enables you to follow the
scan function second for second as each track is
being played.
Hide quick links:
Advertisement
Table of Contents
