Storing Stations On Program Numbers; Naming Stations - Bang & Olufsen BeoCenter 2300 User Manual

Storing stations on program numbers

Once you have found the station you
want and are hearing it clearly in the
loudspeakers, you can store it on a
program number of your own choice.
This enables you to access the station
directly by keying in the appropriate
number.
You can store 15 different radio stations
in each of the two tuner blocks A and B.

Naming stations

You can give a short name of your own
choice to all the stations you have
stored.
This enables you to remember a station
not only by its program number, which
you need for access, but also by a
particular name. The name of the
station you are listening to appears in
the lower display.
Note: The naming function requires that your
BeoCenter is equipped with the RDS facility.
Note: You may store an extra 5 stations in each
block (on the program numbers from 16 - 20), but
the stations on these numbers cannot be named
(see below).
You can use the CLEAR button to clear a program
number entirely, that is, to remove all the data
you have previously stored on it. To do so, press
CLEAR twice while you are on the program
number you want to clear.
C L A S S I C
The name may contain up to 8 characters,
including numbers. If you haven't given a name to
a station, the station's own name appears instead,
providing such a name is transmitted by the
station.
To store the station you are listening
to, press
Key in the number on which you
want to store the station,
for example 1
Press again to store the station
ACCEPTED appears in the display,
indicating that the station has been
stored on the chosen number
Proceed to tune in to the next station
you want, then store it on one of the
other program numbers from 1-15.
Select the program number on
RADIO B
which you have stored the station
STEREO
To access the naming function
The cue NAMING: appears briefly,
then the display blanks. If you have
already entered a name, that name
will appear
The first of the eight character
positions blinks, indicating that you
can start "writing" a name
Reveals the characters one by one
Moves to the next character position
Stores the name
If you want to clear the name press
CLEAR instead of STORE
9
STORE
1
STORE
2 x
GO TO
>
STEP
or
<
STEP
or
STORE