Yamaha XT1200ZE Owner's Manual page 30

INSTRUMENT AND CONTROL FUNCTIONS
When approximately 3.9 L (1.03 US
gal, 0.86 Imp.gal) of fuel remains in the
fuel tank, the last segment of the fuel
meter starts flashing. In addition, the
information display will automatically
change to the fuel reserve tripmeter
3
mode "TRIP-F" and start counting the
distance traveled from that point.
GEAR
4
TRIP-F
In that case, pushing the select switch
switches the display between the vari-
ous information displays in the follow-
ing order;
TRIP-F → Display–1 → Display–2 →
Display–3 → TRIP-F
To reset a tripmeter, use the select
switch to select the information display
that contains the tripmeter. Push the
"RESET" button briefly so that the trip-
meter flashes, and then push the "RE-
SET" button again for at least 2
seconds while the tripmeter is flashing.
If you do not reset the fuel reserve trip-
meter manually, it will reset itself auto-
matically and the display will return to
the prior mode after refueling and trav-
eling 5 km (3 mi).
Estimated traveling range display:
km
The distance that can be traveled with
3.4
the remaining fuel in the fuel tank under
the current riding conditions is shown.
Elapsed time display:
The time that has elapsed since the
key was turned to "ON" is shown. The
maximum time that can be shown is
99:59.
RANGE km
11
TIME TRIP
0:06
3-15
This display is automatically reset
when the key is turned to "OFF".
TIP
There are also "TIME–2" and "TIME–3"
elapsed time displays, but they cannot
be set to the information display. See
"Setting mode" on page 3-17 for de-
tailed information.
Air intake temperature display:
A.TEMP
25
The air intake temperature display indi-
cates the temperature of the air drawn
into the air filter case.
This display shows the air intake tem-
perature from –9 °C to 93 °C in 1 °C in-
crements. The temperature displayed
may vary from the ambient tempera-
ture.
TIP
 –9 °C will be displayed even if the
air intake temperature falls below
–9 °C.
˚C