Circuit Breaker; Tiller Adjustment (4Mph / 6Mph Version); Tiller Adjustment (8Mph Version); Freewheel Lever - Drive Medical Envoy Owner's Handbook Manual

Circuit Breaker. The circuit breaker may trip when
the scooter is under excessive load or when
travelling on steep inclines. It will be more prone to
tripping when the scooter is low on battery charge.
Under normal conditions the circuit breaker button
will protrude by 2mm – 3mm. If the circuit breaker
has tripped the button will protrude by 7mm. To
reset the circuit breaker, push the button in and the
scooter should operate as normal.

Tiller Adjustment (4mph / 6mph version)

Turn the tiller adjustment knob anticlockwise
(towards the scooter seat) to slacken off the tiller.
Move the tiller to the required position and
retighten the knob by turning clockwise (towards the
front of the scooter).

Tiller Adjustment (8mph version)

Push or pull the lever (as shown below) on the tiller
whilst adjusting the angle of the tiller. Release the
lever to lock the tiller in position.
Envoy Electric Scooter

Freewheel Lever

The freewheel levers allows the automatic brake to
be disengaged so the scooter can be manually
pushed and/or manoeuvred. When in freewheel
mode the brakes are not applied so it should not
be used when:
1. Somebody is sat on the scooter
2. If the scooter is left unattended
3. When the scooter is on a gradient
Warning
The lever should only be set to
FREEWHEEL when on flat ground and
unoccupied by the user. Otherwise, there
is a risk of damage or injury.
Page 8 of 16
Engaged (Drive)
Mode:
Push the lever UP
completely and
the scooter can be
driven by the
motor.
Freewheel Mode:
Pull the lever
DOWN and switch
the scooter off.
The scooter can
now be pushed /
moved manually.
Owner's Handbook (Code: Envoy_IFU Iss 01/13)