Wigwag Paddle; Braking; Speed Dial; Speed Setting - Drive Medical Envoy Owner's Handbook Manual

Wigwag Paddle. The scooter is propelled by the
user operating the wigwag paddle at the bottom of
the control panel. To move the scooter forward,
move the right hand side of the paddle towards the
user. To reverse the scooter, move the left hand
side of the lever. The further the paddle moves, the
faster the scooter will travel. To stop the scooter,
release the wigwag paddle and the
electromagnetic brake will apply automatically.
Warning
Do not push both left and right hand
sides of the wigwag simultaneously. You
will not be able to control the scooter.

Braking.

The electromagnetic brake will stop the scooter
when the wigwag paddle is released. The brake is
also automatically applied when the scooter is
switched off.
The 8mph version has a secondary cable brake
which the user can use in an emergency, by
operating the cable brake located on the left hand
side of the tiller handlebars.
When on a gradient, never set the vehicle
to freewheel mode. The brakes will not be
applied.
Speed Dial (4mph and 6mph versions). The top
speed of the scooter can be increased by turning
the dial clockwise, or reduced by turning the dial
anticlockwise.
Speed Setting (8mph version). The top speed of the
scooter can be adjusted by pressing the Increase
Speed and Decrease Speed buttons. The top speed
is shown on the Speed Gauge.
Do not adjust the speed setting whilst
driving as this could result in loss of
control. Do not set the highest speed
whilst driving indoors.
Envoy Electric Scooter
High / Low Speed Setting. When the scooter is
used indoors or in a pedestrian environment (such
as on the pavement or in a shopping mall) the Low
speed setting should be engaged. When the scooter
is used on the road, the high speed setting may be
engaged.
4mph / 6mph versions: To engage the Low Speed
Setting, press the right half of the button (marked
with a dot) and this will limit the scooter's top speed
to 4mph. To engage the High Speed Setting, press
the left half of the button (marked without a dot)
and this will allow the scooter to have a 6mph or
8mph top speed.
8mph version: Press the Indoor Outdoor Switch so
that the 'L' is lit for low speed or the 'H' is lit for high
speed.
Warning
Always engage the Low Speed setting
when travelling indoors or the
pavement. This is a legal requirement.
Horn Button. Press the horn button to sound the
horn, Release the button to stop the horn.
Indicator Buttons. Use the relevant indicators when
making a turn to show your direction of travel. Push
the Indicator button in the direction of travel
required once to operate the relevant indicators.
Repeat to stop the indicators.
Lights Button. Press the Lights button once to
switch on the lights. Press the button again to
switch off the lights.
Hazard Warning Button. Press the Hazard Warning
button once to switch on the warning function.
Press the button again to switch off the function.
When operating the Hazard Warning will flash all
of the indicators and sound the horn.
Page 6 of 16
Owner's Handbook (Code: Envoy_IFU Iss 01/13)