Exterior Cleaning; Drip Tray; Heat Separators, Grilling And Warming Racks; Cast Stainless Steel Burners - Blaze BLZ-3NG Use & Care Manual

HIGH for 5-7 minutes with the hood open. This allows any food particles or grease drippings
to burn away. Once your grill has cooled completely, use a soft brush or vacuum to remove
any ash accumulation on the burner if necessary.

Cleaning Your Grill

NOTE: You should clean your grill after each use to maintain the overall appearance over the
life of your grill. After the first use, it is normal for your grill to become discolored in certain
areas from the heat produced by the burners.

Exterior Cleaning

When cleaning your grill, always scrub and polish in the direction of the stainless steel grain.
Wipe down the exterior of the grill to remove any splatter or grease. Do not use harsh
abrasives. Use a stainless steel cleaner to clean the exterior surface for a polished look. To
remove baked-on foods, use a fine to medium grit non-metallic abrasive pad with a stainless
steel cleaner to avoid specks of grease collecting in the grain causing the appearance of rust.
Before installing the cover, always allow the surface to dry. DO NOT cover a damp grill.

Drip Tray

Clean the drip try after each use. Once the grill has cooled completely, remove the tray by
pulling it all the way out until it comes free. Clean the tray with hot soapy water and re-install.
If using an oven cleaning agent, be sure to carefully follow the manufacturer's instructions to
avoid damage to the stainless steel.

Heat Separators, Grilling and Warming Racks

To clean after each use, turn the grill on HIGH for 5-7 minutes with the hood closed. This
allows any food particles or grease drippings to burn away. Brush components to remove any
remaining charred materials.

Cast Stainless Steel Burners

The grill must be completely cooled before proceeding. Make sure the gas supply is off and
all control knobs are in the "OFF" position. You must remove all cooking grids and flame
tamers to expose the main burners in the grill. On the bottom rear of each burner is a cotter
pin. Remove cotter pin. To remove burner, pull rod upwards and slide burner toward the rear
of the grill. Repeat for each burner. To clean the burners, use a wire brush to clean the
exterior of the burner. Free all clogged ports of obstructions with a small metal object. Clean
Blaze Outdoor Products Instructional Book
Page | 27
Version 1.0