Blaze BLZ-PB-LP Installation And Operating Instructions Manual

Blaze BLZ-PB-LP Installation And Operating Instructions Manual

Power burner

Advertisement

POWER BURNER

MODEL # BLZ-PB-LP/NG & BLZ-PROPB-LP/NG
INSTALLATION AND OPERATING
INSTRUCTIONS
INSTALLER:
Leave these instructions with consumer.
CONSUMER:
READ &
Important:
READ THESE INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION
DANGER
IF YOU SMELL GAS
1. Shut off the gas to the appliance.
2. Extinguish any open flame.
3.
Remove
lid to vent.
4. If odor continues, keep away from the
appliance, and immediately call your
gas supplier or fire department.
CODE AND SUPPLY REQUIREMENTS:
burner must be installed in accordance with local codes
and ordinances, or, in the absence of local codes, with
either the latest National Fuel Gas Code (ANSI Z223.1/
NFPA 54), and Natural Gas and Propane Storage and
Handling Installation Code (CSA-B149.1).
This appliance and its individual shutoff valves must
be disconnected from the gas supply piping system
when testing the system at pressures in excess of
½ psi (3.5 kPa).
This appliance must be isolated from the gas supply
piping system by closing its individual manual
shut-off valves during any pressure testing of the
gas supply system at pressures up to and including
½ psi (3.5 kPa).
retain for future reference.
SAFETY WARNINGS & CODES
:
This power
WARNING
1. Do not store or use gasoline or other
flammable vapors and liquids in the
vicinity of this or any other appliance.
2. A propane cylinder not connected for use
shall not be stored in the vicinity of this
or any other appliance with flame.
WARNING
mproper installation, adjustment, alteration,
I
service, or maintenance can cause injury or
property damage. Refer to this manual. For
assistance or additional information consult
a qualified professional installer, service
agency, or the gas supplier.
All electrical outlets in the vicinity of the power
burner must be properly grounded in
Accordance with local codes or, in the
absence of local codes, with the National
Electrical Code, ANSI/NFPA 70, or the
Canadian Electrical Code, CSA C22.1,
whichever is applicable.
Keep all electrical supply
cords and
fuel
hoses away from any heated surface at all
times including any sharp object.
P a g e
| 1
supply
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the BLZ-PB-LP and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Blaze BLZ-PB-LP

  • Page 1: Power Burner

    P a g e POWER BURNER MODEL # BLZ-PB-LP/NG & BLZ-PROPB-LP/NG INSTALLATION AND OPERATING INSTRUCTIONS INSTALLER: Leave these instructions with consumer. CONSUMER: READ & retain for future reference. Important: READ THESE INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION SAFETY WARNINGS & CODES...
  • Page 2: Safety And Installation Instructions

    P a g e Safety and Installation Instructions When using your Power Burner, please read and follow these basic precautions: POWER BURNER INSTALLATION This Outdoor-cooking appliance (Power Burner) must be installed in accordance with all local and state codes INSPECTED by your local CITY & Fire department. If installation is planned in an area with no local codes, the gas Appliance must be installed in accord with the National Fuel Gas Code ANSI Z223.1 and storage and handling of liquefied petroleum gases, ANSI/NFPA 58 or CSA B149.1 natural gas...
  • Page 3: General Safety Requirements

    P a g e GENERAL SAFETY REQUIREMENTS: 1. The installation of this appliance must conform with local codes or, in the absence of local codes, Either the National Fuel Gas Code, ANZI Z223.1/NFPA 54, or CAN/CGA- B149.1, Natural Gas Installation Code or CAN/CGA-B149.2, Propane Installation Code. 2.
  • Page 4: Ensuring Proper Combustion Air And Cooling Air Flow

    P a g e WHERE TO INSTALL THE POWER BURNER IMPORTANT: THIS POWER BURNER IS FOR OUTDOORS USE ONLY. WARNING The power burner must be installed in masonry or other type of noncombustible surround. The unit is not insulated and therefore must be installed or placed with 16" of side and back clearance from combustible materials such as wood, plastic, or stucco with wood framing.
  • Page 5: Gas Safety Requirements

    P a g e GAS SAFETY REQUIREMENTS Each appliance is set and tested at the factory for the type of gas supply to be used. Identify the Type of gas, either natural gas or LP (Liquid Propane) gas and make sure that the marking on the rating plate located on the side of the unit matches the gas being supplied to the Power Burner.
  • Page 6: Lp Gas Hook-Up

    Only use certified professional installers when using larger L.P tanks. An inline L.P gas regulator is “REQUIRED” and all warranty will be VOID if not installed correctly. Please contact BLAZE to purchase a inline regulator for this power burner.
  • Page 7: Natural Gas Installation

    This Power Burner is fuel convertible and comes with a conversion kit to change to the opposite gas. Please make sure you use a licensed professional to convert and test the power burner. Blaze Outdoor Products Instructional Book Page |...
  • Page 8 7) Turn off the main Gas Supply 8) Call a Certified/qualified professional to repair the GAS LEAK 9) DO NOT attempt to use the power burner until the leak is fixed. Blaze Outdoor Products Instructional Book Page | Version 1.0...
  • Page 9 P a g e TYPICAL BUILDING DIMENSIONS Blaze Outdoor Products Instructional Book Page | Version 1.0...
  • Page 10 A minimum clearance of 1” from the back of the Power Burner Above cooking surface to non- combustible construction is required. A minimum of 1” clearance to the sides of the power burner above cooking surface to non- combustible construction is recommended. Blaze Outdoor Products Instructional Book Page | Version 1.0...
  • Page 11: Cleaning And Maintenance

    Cleaning of the Power Burner would be longer and more difficult if the Power Burner grates are allowed to cool before cleaning. Blaze Outdoor Products Instructional Book Page |...
  • Page 12 Burner. Always keep your face and body as far away as possible when lighting. Refer to spiders and insects warning and procedure under the cleaning and maintenance page of this manual. Blaze Outdoor Products Instructional Book Page | Version 1.0...
  • Page 13 Contact your Gas Professional to bleed out the line. Warning: If you smell gas, shutoff the gas supplies and immediately checks for leaks using the soapy water technique described in this manual. Blaze Outdoor Products Instructional Book Page | Version 1.0...
  • Page 14 Burner LP Orifice-Inner Burner LP Orifice-Outer BLZ-PB-0017 BLZ-PB-0017 Burner LP Orifice-Outer Burner 18 Led Light Switch BLZ-PROPB-0018 19 LED Light - RED BLZ-PROPB-0019 20 Transformer BLZ-PROPB-0020 PRO SERIES – BLZ-PROPB-(LP/NG) BLZ-PB-(NG/LP) Blaze Outdoor Products Instructional Book Page | Version 1.0...
  • Page 15: Warranty Registration

    Warranty Registration If you have purchased a Blaze Series Power Burner you must register your product within 30 days of purchase to validate the warranty and maintain your original receipt to get parts for the appliance. You may register your appliance at blazegrills.com by selecting Support, and then selecting Register your Product.
  • Page 16 Locating the Product Serial Number: The serial number for your BLAZE appliance is located on the left hand outs ide of the Firebox (see picture on page 11.) You will need this number to properly register your appliance and activate coverage. Write this information in the space...
  • Page 17 Please take a minute to let us know what you bought. This makes sure we keep you up to date and have your info ready if you ever need warranty help! You may register your product electronically on the blaze website vs mailing in the below paperwork, blazegrills.com.

This manual is also suitable for:

Blz-propb-lpBlz-pb-ngBlz-propb-ng

Table of Contents