Fuel Conversion – Gas Regulator - Blaze BLZ-3NG Use & Care Manual

5. Push in and turn the control knob to HIGH.
6. If the burner does not light after five seconds, turn the control knobs to the OFF position.
7. Wait five minutes until the gas clears before attempting to light it again.
8. If the burner does not light after several attempts, immediately close all gas valves and
consult an authorized service technician.
"Flashback" may occur in or around the burner tubes. Flashback exhibits a
WARNING:
characteristic "whooshing" sound. If this should occur, immediately turn off your burners,
then remove and clean them with soap and water and a brush until all foreign objects are
removed.
Fuel Conversion – Gas Regulator:
Currently all grills are supplied with a regulator set at 4" of water column pressure which is
appropriate for use with Natural Gas.
When converting to Propane Gas, the most common Propane canister used is a smaller sized
portable canister (typically 5 gallons or 20 pounds).
The pre-installed regulator will need to be removed and replaced with a low pressure hose
and regulator with an outbound pressure set to approximately 11" of water column pressure. If
an individual is intending on using Propane provided from a larger tank permanently installed
on location, the regulator included with the grill can be converted for use with LP fuel (see
NG-LP Regulator Conversion below).
Please be aware that this included regulator can only withstand an inbound pressure of .5 PSI
or roughly 14 inches of water column pressure. Any higher pressure on location will have to
be further regulated before connecting to the regulator on the appliance. Please consult your
local Propane gas provider to confirm the gas pressure on the supply line feeding the grill.
With either setup, remember to always check for gas leaks after the job is complete (see
checking for gas leaks).
Version 1.0
Blaze Outdoor Products Instructional Book
Page | 23