Rear Burner; Optional Infrared Sear Burner; How To Replace Conventional Burner With Infrared Sear Burner; Preheating The Infrared Burner - Blaze BLZ-3NG Use & Care Manual

adjustments to the flame's appearance. To adjust, remove the burner from the grill and
loosen the phillips head screw holding the air shutter to the burner. If the flame is yellow,
open the air shutter to make the flame bluer. If the flame is lifting off of the burner surface,
slightly close the air shutter. Re-tighten the phillips head screw and re-install the burner to
recheck the flame appearance. Repeat if necessary.

Rear Burner

For the Blaze 4 & 5 Burner, replace the back burner orifice by removing the plate on the rear
of the BBQ and carefully removing the fitting. Replace with the provided conversion back
burner orifice – large brass fitting (differs from small BBQ burner orifice).

Optional Infrared Sear Burner

How to Replace Conventional Burner with Infrared Sear Burner

1. To install the optional infrared burner, begin by removing the far left cooking grid, flame
stabilizing grid and zone divider.
2. Remove conventional burner by first removing the cotter pin that holds it in place,
located on the bottom rear of the burner. With the cotter pin removed, remove the
conventional burner.
3. Remove crossfire by removing the Phillips head screw in the middle that holds it in
place. With the crossfire removed, place the infrared burner in place, leaving off the
crossfire and flame tamer.
4. Replace the heat zone divider and cooking grid.
Note: It is critical that the end of the infrared burner is installed appropriately onto the gas
valve to ensure gas flows safely into the burner.
For additional information, contact us at 866-976-9510 or go to Blazegrills.com.

Preheating the Infrared Burner

Always preheat the entire grill before cooking. If the grill is already hot from cooking, you
should still preheat the infrared burner for 3 minutes. Never place food over the burner until it
is fully preheated to avoid clogging the tiny ports and damaging the burner from grease
drippings and food particles.
Infrared Burner Cleaning
To keep your infrared burner operating at maximum performance after each use, turn it on
Version 1.0
Blaze Outdoor Products Instructional Book
Page | 26