Programming The Clearray (Ultraviolet) Water Purification System - Sundance Spas 680 Series Owner's Manual

680 SERIES
10.9 Programming the CLEARRAY (Ultraviolet) Water Purification
System
A. Programming the CLEARRAY System (U) or Corona Discharge
Ozone (O3)
Press and hold the Jets pump 1 (
same time for 3 seconds. Scroll pass the circulation pump programming
menus by pressing the Warmer button, Figure 1.
Note: If your spa is not equipped with a circulation pump you will not
need scroll through the circulation pump programming menus. You will
enter the sanitizing system program, Figure 2.
Figure 1: Menus for spas equipped with a circulation pump.
Figure 2: Menus for spas NOT equipped with a circulation pump.
1. After the last cycle, "C6", the LED screen will display "U" or "O3."
If the LED screen is displaying "U" then pressing the Jets pump
1 will change the sanitizing system from "U" to "O3" and exit the
programming menu. If the LED screen is displaying "O3" then
pressing the Jets pump 1 will change the sanitizing system from "O3"
to "U" and exit the programming menu. You will see one of the two
configurations below:
A. C0, C1, C2, C3, C4, C5, C6, U, 365 (duration countdown timer)
B. C0, C1, C2, C3, C4, C5, C6, O3, =
Note: For the O3 option the "=" disables the duration countdown timer.
2. If you do not wish to change the option do not press any buttons and
after 10 seconds the display will return to the main menu.
Note: If the CLEARRAY System has been selected, when the
time allotted has expired (365 days) the display screen will
flash between the water temperature and "blb." At this time the UV lamp
lamp must be replaced, the quartz tube must be cleaned and the
duration countdown timer needs to be reset.
Page 34
Press Press
Will select "O3"
option and exit
menu.
Press Press
Will take you back
to "C0" option.
Press
or
) and Cooler (
Press Press
Press Press
Press
or
) button at the
Press