Removing The Interface Cable; Configuring The Scanner - Symbol LS3400 Product Reference Manual

Close the clamp, push it back into place and tighten the screws on the clamp to secure the cable into the
4.
bottom of the scanner.
Closing the Clamp
Figure 1-4
Connect the other end of the interface cable to the host (see the specific host chapter for information on
5.
host connections).
Different cables are required for different hosts. The connectors illustrated in each host
NOTE
chapter are examples only. The connectors may be different than those illustrated, but the steps
to connect the scanner remain the same.

Removing the Interface Cable

Loosen the two screws on the cable clamp at the bottom of the scanner and gently pull the clamp away
1.
from the bottom of the scanner.
Open the clamp and unplug the interface cable modular connector from the cable interface port on the
2.
bottom of the scanner handle. Carefully slide out the cable.
Follow the steps for
3.

Configuring the Scanner

Use the bar codes included in this manual to configure the scanner.
Installing the Interface Cable on page 1-2
Getting Started
to connect a new cable.
1 - 3