Removing The Interface Cable; Connecting Power (If Required) - Symbol LS1203 Product Reference Manual

NOTE Different cables are required for different hosts. The connectors illustrated in each host chapter are
examples only. Actual connectors may be different than those illustrated, but the steps to connect the
scanner remain the same.

Removing the Interface Cable

To remove the interface cable:
Unplug the installed cable modular connector by depressing the connector clip with the tip of a screwdriver, or
1.
a paper clip as shown in
Removing the Interface Cable
Figure 1-3
Carefully slide out the cable.
2.
Follow the steps for Installing the Interface Cable on page 1-2 to connect a new cable.
3.

Connecting Power (if required)

If the host does not provide power to the scanner, an external power connection to the scanner is required. To
connect power:
Connect the interface cable to the bottom of the scanner, as described in Installing the Interface Cable on page
1.
1-2.
Connect the other end of the interface cable to the host (refer to the host manual to locate the correct port).
2.
Plug the power supply into the power jack on the interface cable. Plug the other end of the power supply into
3.
an AC outlet.
Figure 1-3.
Getting Started 1 - 3