Beep After Good Decode; Trigger Mode - Symbol LS3400 Product Reference Manual

4 - 6 LS3400 Product Reference Guide

Beep After Good Decode

Scan a bar code below to select whether or not the scanner beeps after a good decode. If Do Not Beep After
Good Decode is selected, the beeper still operates during parameter menu scanning and indicates error
conditions.

Trigger Mode

The scanner has three trigger modes that can be used to scan bar codes. The desired trigger mode can be set
by using the bar codes below.
Level Trigger
When the trigger is pulled, an aiming dot appears for a programmable duration of time. After this time, the
aiming dot automatically turns into a standard laser scanning beam for a full decode session. The laser
scanning beam stays on until the laser-on timeout occurs, a decode occurs, or the trigger is released. If the
trigger is released before the aiming duration expires, the laser shuts off and no decode occurs.
To optimize decode performance, you must set a longer Laser On Time for the attached
NOTE
decoder than the sum of the Aim Duration and the Laser On Time of the LS3400.
Beep After Good Decode
(Enable)
*Do Not Beep After Good Decode
(Disable)
*Level