Removing The Fan Module - NEC EXPRESS5800/120Lf User Manual

3. Check and make sure that the I
the fan cover. If the cable is not routed properly the side cover will not
install correctly. See Figure 4-6.
A
B
4. Reinstall the left-hand side access panel on the system chassis. See Installing
the Side Access Panel earlier in this chapter.
5. Plug in the system power cord(s) and power up the system.

Removing the Fan Module

To remove the fan module, perform the following procedures:
1. Prepare your system for upgrade. See Preparing Your System for Upgrade
earlier in this chapter.
2. Remove the left-hand side access panel of the system chassis. See Removing
the Side Access Panel earlier in this chapter.
For proper cooling and airflow, do not operate the system
with the side access panel removed. Always replace the
panel before powering on the system.
3. If your server is a redundant hot-swap system you must move the hard disk
drive cage(s) in order to free up the fan module so that it is not confined
when sliding it out of the chassis. Otherwise, go to step 6.
4-8 Upgrading Your System
2
C cable is routed through on the inner side of
Incorrect
A – Fan cover
B – Diskette cable
Figure 4-6. Diskette Cable Routing
! CAUTION
Correct