7. Install the two-way SCSI cable or SCSI cable from the SCSI connector on
the system board to the SCSI connector on the rear of the HDD cage.
8. Attach the two power cable connectors to connectors P10 and P11 on the
HDD cage. See Figure 4-53.
9. Install the hot-swap backplane (HSBP) cable from the HSBP-B connector on
the system board to its connector on the HDD cage. See Figure 4-53.
A
B
C
Figure 4-53. Attaching the Power and HSBP Cable Connectors
10. Slide the new HDD cage all the way into the chassis and secure the cage to
the chassis using five screws provided with the upgrade kit. See Figure 4-54
4-54 Upgrading Your System
A
B
C
P11 cable connector
P10 cable connector
Hot-swap backplane (HSBP) cable connector (4-pin)
Figure 4-54. Securing the HDD Cage